![]() The single strand of fiber can get via a duplex fiber, as the following steps show. Optical transceiver loopback test is performed by connecting the transmitter and receiver of the same optical transceiver, to verify if the hardware of the transceiver interface is working properly.įirst of all, before performing a loopback test on an optical transceiver, we need a loopback cable or a single strand of fiber. External loopback guide on the optical module: Take all locally generated transmit data and return it to the receive data path. Run loopback internal command to place the interface in loop internal mode to Internal loopback test is generally configured on the Ethernet switches. How to perform a loopback test on an optical module Internal loopback guide on the optical module: External loopback must be performed at the site. To create a loop, the external loopback requires a cable to physically loop the transmitter signal into the receiver port. External loopback: A loopback test to verify whether the interface correctly sending and receiving packets.Internal loopback can be performed without access to a remote site. It is used to test if the port hardware of the module is working properly in the switch. Put simply, internal loopback refers to data looped internally from Tx to Rx through the internal chip. Internal loopback: A loopback test performed between the transmitter and receiver of a module itself.Soft loopback: A loopback test performed via network management software.That is, data can be directly looped back to receivers through their own transmitters. Hard loopback: A loopback test is performed on physical ports (optical or electrical interfaces) via connection devices or cables.Types of loopback test Hard loopback and soft loopbackīased on different loopback ways, loopback tests can be divided into two types, hard loopback, and soft loopback. Loopback test doesn’t need specific testing devices and software, so it is considered an effective solution to quickly check and locate the failing nodes in a transmission network. In simple terms, in a loopback test, the signal is sent from the tested device and then returned (loopback) to the original place, to determine whether the device is running normally or locate the failed node in the network. It is generally used to verify the optical modules’ interface circuit, internal logic, and hardware implementation of the transmission line are correct. The loopback test is a common testing method used in transmission systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |